Take the strip of fabric scrap for the ears, press it well and fold in on half, lengthwise, right sides together.
Place the template over and trace around it
Pin through both fabrics
Cut out with your scissors.
Sew with 1/4" allowance, leaving a small gap in one of the sides to turn the ear right side out.
Clip the tips and trim the seam in half.
Turn fabrics right side out through the gap.
Push the corners out with a blunt tool (or you can use this method).
Smooth out the seams then iron press.
Fill the ear with poly-fill through the gap.
Cut a piece of wire double in size than the ear.
Fold it in half and twist.
Bend the ends with pliers to form a coil.
Insert the wire inside the ear.
Hand stitch the gap closed using a ladder stitch. Don't worry if your stitch is not perfect, it will be hidden once the hair clip is attached to the bunny ear.
Take the second template and place it on the tie fabric, trace around it then cut out.
Fold the ends of the tie in lengthwise, slightly overlapping them then press well with your iron.
Fold one of the ends in about 1/4" and press well.
Assemble the bunny clip
Take the raw end of the tie and sew it to where the gap used to be, the fold in the tie facing the gap.
Wrap the tie around the ear tightly, two times, until the folded end reaches the raw edge.
Hand stitch the folded end to the ear, without going through all the layers, just through the first and the second layer of the tie.
Insert the hair clip under the tie or glue it to the ear.